Magnacoustics Inc™ © 2012 1-800-637-2282 REV-S 14 |
Genesis ULTRA Installation and Connections
Refer to Stereo Manual for Illustrations and identification of controls.
CAUTION
Ensure that AC cords from the Stereo and Genesis Ultra module are not connected to
power source until all connections are completed. Also ensure that the power entry
receptacle is set up for your voltage 110 / 220
Use Page 16 & 17 for J# Illustrations
1: Place Genesis Ultra module and as close to operator’s console as possible, the floor is
permissible. Place the Stereo on the work station or as close as possible.
2: Place Technologist Control Unit on operator’s console and connect cable from
Technologist Control Unit to J8 on the rear of Genesis Ultra module.
3: Place the speakers on the floor beside the console or other suitable location out of the
way.
4: Connect speaker cables from the speakers to lower terminals marked “SPK 1 AUDIO
OUT” on the Genesis Ultra module. Observe polarity.
5: Connect one side of cable “CB6” 6ft 4-conductor cable to the speaker terminals on the
back of the stereo Red and Black to Left Red and Black, Green and White to Right Black
and Red respectively, the other side of cable “CB6” to the upper terminals of marked
”SPK1 AUDIO IN on the Genesis Ultra module. Follow the same colors and polarity as
you did with the Stereo.
6: Connect one cable CB5 6ft stereo 3.5mm to J1 IN AUDIO on the rear of Genesis Ultra
module, and the other side of CB5 to the rear of the stereo marked J1 Audio.
7: Connect one side of CB7 mono 3.5mm to J7 IR OUT on Genesis Ultra module the other
side to on the rear of the stereo market J7 IR.
Caution: CB5 and CB7 look alike, please do not misconnect! If they are connected wrong
the patient will only hear music on one channel (CB5 goes to J1 and CB7 goes to J7)
8: Place the Intercom Mic on the Operators Console and plug the cable into J4 on the rear of
Genesis Ultra module. Make sure the MIC slide switch on stalk is turned on.
If you are installing the Intercom Integration Kit follow steps 9 – 13, if not go to step 14
9: Connect the round AMP end of “CB3” 10ft. DB9 to Male AMP Cable to J5 on the rear of
Genesis Ultra module.
10: Connect the DB9 end of “CB3” to the DB9 on the AutoVoice Breakout Box.
11: For Horizon LX locate Run 788 and remove the DB25 from J7 on the WIM Module and
connect to the DB25 on the AutoVoice Breakout Box, then connect “CB4” to the other
DB25 on AutoVoice Breakout Box, and connect the other end of “CB4” to J7 on the WIM
Module.
(17 stránky)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Komentáře k této Příručce